Quickjack 3500SLX Manuel page 41

15. After 3 to 4 seconds release Down.
Holding the Down button for those 3 to 4 extra seconds helps to relieve hydraulic pressure in the
system.
16. Visually check to make sure both QuickJack Frames are engaged on the same locking position.
The following graphic shows the Release Cam
your Frames like this!
⚠
WARNING
You can work on your Vehicle once you have visually confirmed that both Frames are engaged on the
same locking position and that all Lift Blocks are in contact with the Vehicle at the factory-
recommended Lifting Points.
⚠
WARNING
QuickJack™ Portable Car Jack
Before doing anything else (like starting work on the Vehicle or leaving the area),
visually confirm
that
and that all Lift Blocks are in contact with the factory-recommended Lifting Points
of the Vehicle.
As an added safety precaution, you must
the Vehicle while elevated on both QuickJack Frames.
not
engaged on a locking position; do
both
QuickJack Frames are on the same locking positions
always
41
P/N 5900263 — Rev. B1 — September 2021
not
use auxiliary safety stands under
leave