Quickjack 3500SLX Manuel page 20

Installing the Hydraulic Elbow Fittings
You need to install one Hydraulic Elbow Fitting (5550103) on each Hydraulic Cylinder.
Tip
To install the Hydraulic Elbow Fittings:
1. Remove the shipping plug from the Hydraulic Cylinder Port using a 6 mm Hex Key.
2. Take a Hydraulic Elbow Fitting from the Parts Bag and attach the ORB end into the Hydraulic
Cylinder Port.
Important:
Drawing shows the hydraulic connections to make to the bottom of the Hydraulic Cylinder. Not all
components are shown.
3. Position the threaded fitting end as shown above; accessible but not pointed up.
You want the threaded fitting end accessible but
would then angle up and could possibly impact the underside of a Vehicle.
4. Turn the Nut until fully snug.
5. Perform the same process for the Hydraulic Cylinder on the other QuickJack Frame.
QuickJack™ Portable Car Jack
Raising the QuickJack Frame and putting a Lift Block under it or manually raising the
Platform to a locking position can provide a little bit of extra room, making it easier to
secure the Hydraulic Elbow Fitting.
not
Do use Thread Sealant on either end of the Hydraulic Elbow Fitting.
not
pointed up, as the Short Hydraulic Hose
20
P/N 5900263 — Rev. B1 — September 2021