Quickjack 3500SLX Manuel page 17

Unpacking
Open the boxes and arrange the QuickJack components where you will be setting them up.
The components needed to set up a QuickJack:
• Box 1. Includes the Left Frame.
• Box 2. Includes the Right Frame.
• Box 3. Includes the Power Unit (Voltage decided at time of purchase), Parts Bag, Hydraulic
Hoses, 4 Medium Lifting Blocks, and 4 Tall Lifting Blocks.
⚠
WARNING
⚠
CAUTION
QuickJack™ Portable Car Jack
Your two QuickJack Frames are similar, but they are
line up your Frames as parallel to each other as the Lifting Points will allow, with the
Lock Bars on the outside
Be sure to route the Short Hydraulic Hoses
are routed over the QuickJack Frames, the QuickJack will not work correctly and
the Hoses could be damaged.
, as shown below.
under
17
P/N 5900263 — Rev. B1 — September 2021
not
interchangeable. Always
the QuickJack Frames. If they