Quickjack 3500SLX Manuel page 28

The following drawing shows the 220 VAC Power Unit for QuickJack (CE-approved).
Drawing not necessarily to scale. Some Power Units may be slightly different.
Power Sources for 12 VDC Power Units
If you are using a 12 VDC Power Unit with your QuickJack, you can connect it to a Vehicle battery.
Refer to Using the 12 VDC Power Unit
12 VDC Power Unit
Drawing not necessarily to scale. Some Power Units may be slightly different.
Keep the following in mind:
• Connect your 12 VDC Power Unit directly to a 12-volt power source. The minimum requirement for
Jumper Cables is 7 gauge / 10 mm.
• Make sure to connect the 12 VDC
and the 12 VDC positive (red, +) power source to the positive (red, +) terminal.
• Remove all jewelry while working with the 12 VDC Power Unit.
⚠
WARNING
QuickJack™ Portable Car Jack
negative
Make sure to connect Positive to Positive and Negative to Negative. If you
connect Positive to Negative, you will almost certainly cause damage to the
electrical system of the Vehicle, including the battery. You could also damage the
12 VDC QuickJack Power Unit, cause an electrical fire, or cause an explosion.
for usage information.
(black, –) source to the
28
P/N 5900263 — Rev. B1 — September 2021
negative (black, –) terminal