Quickjack 3500SLX Manuel page 23

Preparing the Short Hydraulic Hoses
To prepare the Short Hydraulic Hoses, you will need from Box 3:
• Two Short Hydraulic Hoses (5570233).
• Two Male Quick-Connect Fittings (5550032).
The following graphic shows the connections to make to the Short Hydraulic Hoses.
To set up and connect the Short Hydraulic Hoses:
1. Locate both Short Hydraulic Hoses and remove their protective caps.
2. Prepare the threaded fitting on the male end of each Short Hydraulic Hose with Thread Sealant.
3. Attach a Male Quick-Connect Fitting to the male threaded end of the Short Hydraulic Hose; make
2-3 full turns using a wrench to securely tighten in place.
4. Connect the other end of the Short Hydraulic Hose to the male connector on the Hydraulic Elbow
Fitting on the Hydraulic Cylinder; make 2-3 full turns using a wrench to securely tighten in place.
5. Route both Short Hydraulic Hoses
⚠
CAUTION
QuickJack™ Portable Car Jack
under
If you mistakenly route a Short Hydraulic Hose over the QuickJack Frame, the
QuickJack will not work correctly and you could damage the hose and/or cause the
Vehicle on the QuickJack to become unstable.
keep them clear of pinch points!
the Frame ends;
23
P/N 5900263 — Rev. B1 — September 2021