Quickjack 3500SLX Manuel page 34

Be sure to use the factory-recommended Lifting Points for the Vehicle.
7. Press Up on the Pendant Control for a couple of seconds.
After a few seconds, the QuickJack Frames will start moving up. As this is the first use, it takes a
couple of seconds for the Hydraulic Hoses to fill with fluid.
If the QuickJack Frames do not move, make sure the Power Unit is connected to an appropriate
power source, make sure the Hydraulic Hoses are connected to the Power Unit, and make sure
there is sufficient Hydraulic Fluid in the reservoir. If you find any of these issues, fix them and then
try again. If the Frames still do not move, refer to Troubleshooting.
before
8. Just
9. Check the locations where the Lift Blocks will hit the Lifting Points. If necessary, adjust the Lift
Blocks so they are properly positioned.
10. Press Up to raise the Frames to just past the First Locking Position, then press Down for 3 to 4
seconds.
⚠
WARNING
The Lock Bar will lock at the First Locking Position and the Frames will stop moving.
11. With the QuickJack engaged on the First Locking Position, check all Hydraulic Hose connections
for leaks. If you find any, tighten the leaking connection and wipe up the fluid.
If the motor gets hot or sounds irregular, check the Power Unit and all electrical connections.
12. Carefully rock the Vehicle to test its stability.
If the Vehicle seems stable, the QuickJack is ready for normal operation.
If the Vehicle does
Lift Blocks in the Receiver Trays.
13. If everything appears to be working normally, lower the QuickJack Frames back down to the
ground. To do this: press Up for a second or two so that the Lock Bars go past the Lock Blocks,
then press Down until the Lock Bars lower past the Lock Blocks.
When the Frames get to the ground, hold Down for another ~5 seconds so that the Hydraulic
Fluid returns to the reservoir.
If there are issues you cannot resolve, stop using the QuickJack, then refer to Troubleshooting,
or call QuickJack at (888) 262-3880 or (805) 933-9970.
Leave the Manual with the Owner/Operator
Make sure to leave the Setup and Operation Manual with the owner/operator so that it is available to
everyone who is going to use the QuickJack.
QuickJack™ Portable Car Jack
the Frames make contact with the Lifting Points on the Vehicle, release Up.
If one Frame goes up faster than the other with the weight of a Vehicle on it, this is
a safety hazard. Release Up immediately and then press Down to lower the
Vehicle back down to the ground. Wait a minute and then try again. If the issue
continues, refer to Troubleshooting.
not
seem stable, lower it back to the ground and check the positioning of the
34
P/N 5900263 — Rev. B1 — September 2021