Video Light - Metz mecablitz 26 AF-1 digital Mode D'emploi

Testing remote flash mode
• Place the slave flash units in the desired positions for
the shot. Use flash unit mounting foot S60 (optional
accessories) to set up the slave flash unit.
• Wait for the flash readiness of all connected flash
units. Once the slave flash units have achieved flash
readiness, the "STATUS" LED
• Press the manual firing button on the master or
controller flash unit to fire a test flash. The slave flash
units respond with a test flash, if supported by the
camera.
If a slave flash unit does not issue a test flash, correct
the position of the slave flash unit to enable the slave
sensor to receive the light sent by the master/con-
troller flash unit.
k
98

5.5 Video light

Use the video light to illuminate shots of moving images
at close range.
• Press button
• Press the "LED" button
lights up in green.
If the "LED" button
set the full light output; if it blinks slowly, the light output
is set to half.
If the batteries are almost empty, the video light
switches off and the "LED" button
briefly.
The flash unit always switches on afterwards with the
mode of operation that was used last.
on the video light. Each time you press the "LED"
button , the light output switches between "full"
and "half"
lights up continuously, you have
on the flash unit to switch
blinks quickly.