Roco 10885 Mode D'emploi page 17

Parameter for analog & DCC assignment
CV Value Decoder output
121 8 F0v, Light forwards
131 8 F0r, Light backwards
Blinking light
CV Value Decoder output
122 18 F0v, Light forwards
132 18 F0r, Light backwards
123 47 F0v, Light forwards
133 47 F0r, Light backwards
Number of blink-/switch cycles
CV Value Decoder output
124 0 F0v, Light forwards
134 0 F0r, Light backwards
8010885920 XII_2012.indd 17
Description Settings
Bit 0: Brightness, dim value: 1=on,0=o�
Brightness, dim value of
Bit 1: Brightness, dim value: 1=on,0=o�
resp. output: Bit 0-3: The
Bit 2: Brightness, dim value: 1=on,0=o�
light can be dimmed in 16
Bit 3: Brightness, dim valuet: 1=on,0=o�
steps (0-15)
Bit 4: Function is on in direction:
Parameter for analog &
DCC assignment: Bit 4-7:
Bit 5: Output depends on direction:
Bit 6: Function valid for: 1=DCC and analogue:
Bit 7: Function is active at:
Description
Switch-on duration of output
with blinking function
Switch-o� duration of output
with blinking function
Description
Number of blink-/switch cycles for
blinking light-/switch-function.
1-255 blink-/switch cycles are
carried out with each function
transmitted by the DCC controller.
If the function is stopped by the
controller, the procedure will be
ended, even if some of the blink-
switch cycles are left over.
0=forwards, 1= backwards
1=on, 0=o�
0=DCC
1=only when running,
0=running and at standstill
Settings
1-255: 0,1s-25,5s
0: Light, switch-output permanently
blinking
1-255: 0,1s-25,5s
0: Light, switch-output permanently
blinking
Settings
1-255: 1-255 Number of blink-/switch
cycles
0: Light, switch-output permanently
blinking
Part-
value
0/1
0/2
0/4
0/8
0/16
0/32
GB
0/64
0/128
17
05.12.2012 12:27:08