Roco 10885 Mode D'emploi page 16

Dimming and adjustment of light outputs
In the CVs 121 and 131 you can carry out various adjustments of the 2 light outputs. If you
program the total value of a CV (byte-wise programming), each partial value of the adjusted bit must be added and
programmed together. The outputs F0v, F0r may be used in the following operation modes: 1. Light output, 2. Light
output with blinking function. Important: For F0v and F0r: The selection of the running direction in CV121, resp.
CV131 Bit4 must be identical with the selection of the light output in the function mapping of CV33 and CV34. Other-
wise both adjustments will cancel each other out. The decoder is adjusted to automatically detect analogue or DCC
operation. The light outputs are pre-adjusted active only in DCC operation. This adjustment was made because, in
analogue operation, the outputs will work correctly only, if the connected LEDs or lamps are switched to V+ (blue line
of the decoder ) and not against the left-side of the track.
GB
RailCom
1)
The decoder in this vehicle has "RailCom
data to a RailCom 1) -enabled control centre. For more information, please see the instructions for your RailCom
led control centre. By default RailCom1) is switched on (CV29, Bit 3=0). For operation with a control centre that does
not have RailCom , we recommend that RailCom
1)
Setting the outputs as light output / switch output (basic setting)
Light output /Switch output
CV Value Decoder output
120 0 F0v, Light forwards
130 0 F0r, Light backwards
Parameter for analog & DCC assignment
CV Value Decoder output
121 8 F0v, Light forwards
131 8 F0r, Light backwards
Setting the outputs as light output / switch output (blinking function)
Light output /Switch output
CV Value Decoder output
120 1 F0v, Light forwards
130 1 F0r, Light backwards
16
8010885920 XII_2012.indd 16
," i.e. it not only receives data from the control centre, but also it can send
1)
be switched o�.
1)
Description
Operation mode of decoder output
is light-/ switching output
Description Settings
Bit 0: Brightness, dim value: 1=on,0=o�
Brightness, dim value of
Bit 1: Brightness, dim value: 1=on,0=o�
resp. output: Bit 0-3: The
Bit 2: Brightness, dim value: 1=on,0=o�
light can be dimmed in 16
Bit 3: Brightness, dim valuet: 1=on,0=o�
steps (0-15)
Bit 4: Function is on in direction:
Parameter for analog &
DCC assignment: Bit 4-7:
Bit 5: Output depends on direction:
Bit 6: Function valid for: 1=DCC and analogue:
Bit 7: Function is active at:
Description
Operation mode of decoder output is
light-/switching output with blinking
function
Settings
0: Output is light-/ switching output
0=forwards, 1= backwards
1=on, 0=o�
0=DCC
1=only when running,
0=running and at standstill
Settings
1: Is light output / switch output with
blinking function
1) -enab-
Part-
value
0/1
0/2
0/4
0/8
0/16
0/32
0/64
0/128
05.12.2012 12:27:08