Operating Modes - Roco 10885 Mode D'emploi

Automatic detection of operating modes digital - analog

Small size

Short and extended (4-digit) addresses as well as 14, 28 and 128 travelling stages (DCC)

High-frequency (approx. 20kHz) motor control (15 - 22kHz adjustable)

Switchable shunting gear, adjustable minimum, medium and maximum speeds

(Shunting gear switchable with F4 key)
Load control

Programming possible while travelling

Overload protection,

RailCom
1)

Can be updated

The Decoder
The decoder is only to be installed in model locomotives and cabins. A different use is not permitted!

Operating Modes

 Digital multi-train operation with NMRA compatible systems as:
– multiMAUS, multiMAUS
– Lokmaus 2 / PowerMouse, Lokmaus R3 (art. no. 10760, 10860, 10790 und 10792)
– ROCOMOTION (art. no. 10785)
 Locomotives with factory-equipped interface according to NEM 651
The use of this Decoder in other than the previously listed digital systems or in power units which are not factory-
equipped with NMRA or NEM (see above) conforming Decoder interfaces (installation by e.g. cutting the interface
plug and soldering of the Decoder into the locomotive) can cause irreparable damage to the Decoder or the loco-
motive. ROCO cannot be held liable in such events for the Decoder or the locomotive or any guarantee. Damage
caused by any other changes to the Decoder (e.g. applying paint) are also excluded from any guaranties.
The decoder is equipped with protective devices to prevent excessive currents on the motor and light outputs.
However, this does not exclude damage for instance through short circuits between current collector and motor,
short circuit between motor output and locomotive chassis and overloading of the decoder. The decoder must only
be used in model trains.
Operating the decoder on analogue alternating current systems with change-over impulse is not permissible! The
change-over impulse will destroy the decoder.
Locomotive address
The factory-set default address of the Decoder is 03. To programm a new address please refer to the Lokmaus
manual or the Instruction Sheet of your digital system.
Programming for the Decoder
See multiMAUS, multiMAUS
8010885920 XII_2012.indd 11
Receiver Module Features at a Glance
Short-circuit proof with switch-o�
or Z21
pro
pro , Z21 or Lokmaus -Manuel.
GB
® 2
11
05.12.2012 12:27:06