Tracing Energized And De-Energized Wires - Tip Sensor - Amprobe AT-8000 Advanced Wire Tracer Guide De Démarrage Rapide

Tracing Energized and De-energized Wires - Tip Sensor

Set-up:
1
Test Leads
AT-8000-T
Proper connection
with separate
ground
1. Plug the green and red test leads into the Transmitter.
2. Connect the green wire to a separate ground.
3. Connect the red test lead to the wire being traced.
For receptacles, make sure to connect the test lead to
the line (hot) wire. For Energized systems the signal
will ONLY be transmitted between the load-side to
which the Transmitter is connected and the source
of power.
Set-up:
2
Transmitter
Transmitter
indicator showing
signal in
HIGH mode
1. Turn on the Transmitter.
2. Verify that the test leads are properly connected;
the red LED voltage status light should be on
for circuits with voltage above 30 V AC/DC, and
it should be off for De-energized circuits below
30 V AC/DC.
3. Select HIGH signal mode by pressing HI.
AT-8000-T
TRANSMITTER
Blinking
HI
LO
©2020 Amprobe
Advanced Wire Tracer - Quick Guide
Receiver:
Energized and De-energized
Tip Sensor Modes
Use this mode for pinpointing a wire in a bundle or
tracing in corners and confined spaces such as junction
boxes and inside enclosures.
TIP SENSOR ENERGIZED
30-600V AC/DC
40-400 HZ
Receiver screen showing signal detected in
Energized TIP SENSOR mode
1. Turn on the Receiver and select either Energized
or De-energized TIP SENSOR mode using the
directional arrows.
2. Hold the Receiver with the Tip Sensor facing the
target area.
3. Scan the target area with the Tip Sensor to find the
highest signal level, then begin tracing the detected
wire. Increase or decrease sensitivity of the Receiver
by pressing + or - on the keypad as necessary.
4. Press ENTER when complete to return to the
home screen.
TIP: In Energized mode, align the groove on the Tip
Sensor with the wire direction for best results; the
signal may not be detected without this alignment.
De-energized mode uses a different antenna in the
Tip Sensor than Energized mode. Specific alignment
of the Tip Sensor groove to the wire is not required.
De-energized wire tracing results are based only on
how close the Tip Sensor is to the wire.
Tip groove
Aligning the Tip Sensor with the wire
For detailed specifications and ordering go to amprobe.com 6012404 A
®
Align
75
SIGNAL
3