gdw 1270 Mode D'emploi page 7

Trekhaken
Bouten – Boulons – Bolts - Bolzen
Kwaliteit 8.8
M6  10,8Nm of 1,1kgm
M12  88,3Nm of 9,0kgm
Bouten – Boulons – Bolts - Bolzen
Kwaliteit 10.9
M6  13,7Nm of 1,4kgm
M12  122,6Nm of 12,5kgm
Attelages
Uitsnijding bumper :  het gearceerde gebied moet weggesneden worden
Découpe pare-chocs :  la zone hachée doît être découpée
Excision bumper :  the hatched area has to be cut away
Ausschnitzung Stoßstange :  das schraffierte Gebiet muß weggeschnitten werden
M8  25,5Nm of 2,60kgm
M14  137Nm of 14,0kgm
M8  35,3Nm of 3,6kgm
M14  194Nm of 19,8kgm
Anhängevorrichtungen Tow bars
"B" = de bumper
"O" = de onderrand van de bumper
"M" = het midden van de bumper
"B" = le pare-chocs
"O" = le bord inférieur du pare-chocs
"M" = le milieu du pare-chocs
"B" = the bumper
"O" = the lower rim of the bumper
"M" = the middle of the bumper
"B" = Stoßstange
"O" = Unterrand Stoßstange
"M" = der Mitter von Stoßstange
DIN 912 - DIN 931 - DIN 933 - DIN 7991
M10  52,0Nm of 5,30kgm
M16  211,0Nm of 21,5kgm
DIN 912 - DIN 931 - DIN 933 - DIN 7991
M10  70,6Nm of 7,20kgm
M16  299,2Nm of 30,5kgm