Fein WSG20-180 Serie Mode D'emploi page 22

OBJ_BUCH-0000000399-001.book Page 22 Thursday, December 19, 2019 1:31 PM
en
22
Grinding (figure 11).
Observe a lead angle of 20 – 40°. This will
ensure a good removal rate.
Apply uniform pressure with the power
tool and move it over the surface.
Avoid excessive heating of the work-
piece surface.
Cutting (figure 12).
Always work in an up-grinding motion,
so that the cutting disc will not jump out
of the cut.