Fein WSG20-180 Serie Mode D'emploi page 16

OBJ_BUCH-0000000399-001.book Page 16 Thursday, December 19, 2019 1:31 PM
en
16
Mounting the wheel guard (figure 3).
For all work except for cut-off
WARNING
grinding.
Release clamping lever.
Insert the nose of the wheel guard into the
groove of the power tool.
Turn the wheel guard to the requested work-
ing position, then clamp the wheel guard with
the clamping lever.
If the wheel guard is not tightly seated after
clamping, tighten the locking screw.