TUBESCA-COMABI SPEEDY 3 EXPORT Manuel De Montage Et D'utilisation page 31

SPEEDY 3 EXPORT
2-2-2 / Stabiliser assembly
Installation of stabilisers fastened to the uprights by means of two wing nut clamps:
The stabiliser clamps must abut against the rung concerned (see diagrams chapter 1-4).
These stabilisers are extendible:
Press on the pins in the centre of the main tube...
Assemble the stabilisers on the uprights of the scaffolding observing the values and quantities in the diagram below:
3944
132°
Assembly along a wall
132°
3944
3380
90°
unscrewing
...and slide both tubes
into their new position
allowing the pins to fall into the holes in the main tube
tightening
Page 10 of21