GreenWorks GDC60 Manuel D'utilisation page 3

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SV HR HU RO BG EL AR TR HE LT LV ET
ASSEMBLING THE BUCKET (See Figure 3.)
„ Align the water inlet (10) on the base unit with the
outlet(11) on the bottom of the bucket, and seat the
bucket on the base unit.
„ Check alignment to ensure a proper seal and
connection.
„ Flip up the buckles on the base unit and latch to
bucket. Press down on the buckle ends to lock the
bucket to the base unit
BTTERY INSTALLATION (See Figure 4.)
„ Open the door of the battery housing.
„ Align groove in battery pack with raised rib on
pressure washer.
„ Make sure the latch on the pressure washer snaps
in place and that battery pack is secured in pressure
washer before beginning operation.
„ Close the door.
BATTERY REMOVEL (See Figure 4.)
„ Set the switch to the OFF position.
„ Press the button and take out the battery.
OPERATION
Applications
This pressure washer can be used for the purposes
listed below:
„ Removing dirt and mould from decks, cement
patios, and walls.
„ Cleaning cars, boats, motorcycles, outdoor furniture
and barbeques.
CONNECTING HIGH PRESSURE HOSE (See Figure
5.)
Fiting
„ Push the connector (12) of the high pressure hose
into the mount (13) on the trigger handle until it
engages.
Removing
„ Actuate the spring button (14) and pull the high
pressure hose out of the mount.
The washer must be used on a secure and stable
surface in a standing, upright position.
English (Original instructions)
WARNING
ADDING WATER TO THE BUCKET (See Figure 6.)
The water supply must come from a water main.
NEVER use hot water or water from ponds, lakes, etc.
For ease of use, a self-coiling hose (not provided) is
recommended.
Always switch off the mains disconnecting switch
when leaving the machine unattended
Do not fill the bucket with the bucket still fixed on
the base unit.
Before adding water to the bucket:
„ Inspect the filter in the water intake.
„ If the filter is damaged, do not use the machine until
the filter has been replaced.
CONNECTING THE WATER SUPPLY TO PRESSURE
WASHER (See Figure 7.)
NOTE: If you do not want to use the bucket, you can
use the base unit directly as a pressure washer.
„ Connect a garden hose to the water inlet.
„ Attach a garden hose to water supply.
When connecting the appliance to the water sup-
ply mains (not public drinking water supply mains),
please observe the local regulations of local boards
or local water supplier.
To ensure that there is no feedback of contaminant
into the water supply, the appliance must not be con-
nected directly to the public drinking water supply
mains.
If the appliance is connected to potable water mains,
backflow prevention devices should be incorporated
in or fixed to the water supply system. The instal-
lation should be accepted by local boards or water
supplier and should be conducted by professional
technical personnel. The backflow prevention de-
vices should be appropriate to fluid categories and
comply with the requirement to avoid back siphon-
age according to EN 60335-2-79:2009.
3
WARNING
WARNING
CAUTION