Configuration Mode; Enabling The Accessory Modules - CARLO GAVAZZI WM20 Manuel D'instructions

Configuration mode

Configuration of the accessory modules and settings of the main unit parameters can be
performed before or after installation, but only when the icon
Parameters for the accessory modules can only be set when the modules are connected
to the main unit.
The parameters can be set in two ways:
• via the keypad of the main unit, see "Settings menu" on page 24
• using the UCS configuration software via the communication module with Modbus
protocol, see "Communication module overview" on page 59 or front optical port
via OptoProg (see relative documentation).

Enabling the accessory modules

The accessory modules must be enabled. The enable command can be automatic or
manual.
Enable
Automatic
Manual
NOTE *: module enabled only if no other communication module has been installed.
48
8021572 | WM20 | © 2016 | CARLO GAVAZZI Controls SpA
Description
The module is automatically detected and
enabled
The module must be enabled via the
settings menu, see "Settings menu" on
page 24
is displayed.
Modules
• M C EtH
• M C BAC iP
• MC BAC MS
• M C PB
• M O R2
• M O O2
• M C 485232 *