Sealing The Terminals On The Main Unit - CARLO GAVAZZI WM20 Manuel D'instructions

Operation Procedure
if the main
Locking the
unit ...
configuration
has no
accessory
modules
connected
is connected
to accessory
modules

Sealing the terminals on the main unit

Fig.10
1. Remove the terminals.
2. Apply the four seals, each in a hole of the main unit [A].
3. Refit the terminals.
4. Position the terminal caps, passing the seals through the corresponding
holes of the caps [B].
5. Close the seal.
then...
position the rotary selector at the rear of the module
to 7.
1. Disconnect the power supply and load
2. Remove the accessory modules
3. Position the rotary selector at the rear of the main
unit to 7.
4. Re-install the modules and reconnect the power
supply and load.
8021572 | WM20 | © 2016 | CARLO GAVAZZI Controls SpA
17