Transportation - Husqvarna HTC 950 RX Manuel De L'opérateur

HTC 950 RX
Warning!
This symbol means Warning! and indicates a risk of personal injury or material
damage in the event of incorrect use of the machine. If you see this symbol next
to a section of text, you must be particularly careful when reading through the
text and not carry out any stages of which you are unsure. This is for your own
and other users' safety and to avoid damage to the machine.
Note!
This symbol means Note! and indicates a potential risk of material damage in
the event of incorrect use of the machine. If you see this symbol next to a
section of text, you must be particularly careful when reading through the text
and not carry out any stages of which you are unsure. This is to avoid damage
to the machine.
Tip!
This symbol means Tips! and implies the inclusion of tips and advice on
effective use of the machine or ways of reducing wear and tear to the machine.
If you see this symbol next to a text, you should read through the text to make
your work easier and to extend the service life of the machine.
1.4

Transportation

Warning!
Never deactivate the radio control function when you have stopped the machine
on a sloping surface during loading, since the machine can start to roll.
Note!
The machine cannot be moved manually if the drive wheels are locked and the
radio control activated.
Always make sure that the grinder is securely anchored to its surroundings and the
grinding head is lowered against the surface. Make sure that the securing straps, or other
equipment used for anchoring during transport, are tightened over non-moving parts,
e.g. the grinder's chassis.
The machine can also be transported with other lifting equipment, for example truck or
crane, using the lifting eyes provided, position 3, Figure 3-1, page 11. In which case,
make sure that the weights are locked in the forward position and that the handle is in its
back position, see Figure 4-6, page 21 and Figure 4-2, page 18.
When lifting the grinder, lifting straps must be used. These must be attached
well-secured in the lifting eyes provided, position 3, Figure 3-1, page 11. Only use
lifting straps approved for lifting equipment.
5.0
Introduction
3