Start The Machine - Radio Control; Stop The Machine - Radio Control - Husqvarna HTC 950 RX Manuel De L'opérateur

HTC 950 RX
4.12.3

Start the Machine - Radio Control

Note!
To save energy, the radio control unit automatically switches off if a button is
not activated within a given time. in which case, the blinking points in the
display are extinguished.
1. Turn the knob "Radio On/Off" on the control panel to the right, to prepare the
machine for manoeuvring via the radio control unit, the indicator "Radio Enables"
on the control panel lights up.
2. Press the button "EM-STOP" and then press the button to start the radio
communication on the radio control unit to activate the radio control. The buttons
can be activated in any order, but after you have pressed the first button the second
must be pressed within 5 seconds. When the radio control is activated, the two
points start blinking alternately with a red light on the control unit's display.
3. Zero the radio control unit by doing the following:
- Turn the knob for speed (SPEED) to "min".
- Set the control for driving forwards/backwards (FWD/RWD) in the middle
position.
- Turn the knob for the rotational speed (GRINDING SPEED) to 0%.
- Move the control for starting and stopping the grinding discs' rotation (ON/STOP)
to STOP.
4. Press the button to start radio communication. The communication error indication
(ComError) on the machine's control panel should then go out.
5. Start the grinding discs' rotation by moving the control "ON/STOP" to ON. Adjust
the rotational speed with the knob "GRINDING SPEED".
6. Start the machine's drive motors by moving the control "FWD/RWD" to FWD.
Adjust the speed with the knob "SPEED".
Check that the wheel lock is secured between the wheel and the drive motor,
see Figure 4-3, page 19.
4.12.4

Stop the machine - Radio control

1. Turn the knob for speed (SPEED) to "min".
2. Set the control for driving forwards/backwards (FWD/RWD) in the middle position
so the machine stops.
3. Turn the knob for the rotational speed (GRINDING SPEED) to 0%.
4. Move the control for starting and stopping the grinding discs' rotation (ON/STOP)
to STOP.
5.0
Operation
31