Using The Support Wheel - Husqvarna HTC 950 RX Manuel De L'opérateur

HTC 950 RX
1. Decouple the wheels by pulling the locking pin straight out, see Figure 4-3, page
19.
Figure 4-3. Decouple the wheels
2. Turn the locking pin 90 and release it for the secured position, see Figure 4-4, page
19.
Figure 4-4. Turn 90 degrees
In order to couple the wheels to the drive motors, the same steps as above are carried
out.
Tip!
During troubleshooting, the wheels can be decoupled from the motors and test
driven without the machine moving.
4.4

Using the support wheel

The support wheel is used to make it easy to move the grinder. It is fitted at the front on
the grinder's chassis next to the grinding head. The support wheel is secured to the
chassis by pushing the pin through the hole in the support wheel's construction and the
chassis front frame according to Figure 4-5, page 20. Make sure the pin goes down
and locks properly.
Rotate the crank on the front of the support wheel to adjust the height so the machine
tilts and the grinding head hangs completely free of the surface. The grinder can be
moved by manually pushing it front of you. Make sure the wheel lock is released
according to Figure 4-3, page 19.
5.0
Operation
19