Manoeuvring Via The Radio Control Panel; Preparation; Standby - Husqvarna HTC 950 RX Manuel De L'opérateur

Operation
4.12

Manoeuvring via the radio control panel

During radio control, the machine is manoeuvred via the radio control unit,
see Figure 3-4, page 14.
When operating via the radio control unit, the machine is driven forwards with the help
of the motors in the drive motor box. From a work environment perspective, operation
via the radio control unit is recommended.
Warning!
The operator must never leave the machine unattended.
4.12.1

Preparation

1. Loosen the battery cover on the radio control unit by screwing loose the screws on
the cover.
2. Place two charged AA batteries 1.2 V NiMH, or alternatively two normal,
non-rechargeable 1.5 V AA batteries in the battery space.
Note!
Rechargeable batteries must be fully charged before they are used for the
same time.
Warning!
Never attempt to charge standard, non-rechargeable 1.5 AA batteries.
3. Close the cover and fasten it in place with the screws.
Check that the wheel lock is secured between the wheel and the drive motor,
see Figure 4-3, page 19.
4.12.2

Standby

To activate the machine's functions, turn the key to the right. When the key is in this
position, the Power green indicator light on the control panel is lit, indicating that the
machine is in standby mode.
30
HTC 950 RX
5.0