Resetting The Frequency Converter; Checking The Last Error Code - Husqvarna HTC 950 RX Manuel De L'opérateur

Electronic error codes
7.2.2

Resetting the frequency converter

1. Switch off the machine by turning the start key to "Off" .
2. Wait until the display goes out.
3. Reset the emergency stop switch.
4. Start the machine by turning the start key to "On".
Tip!
The machine will not start if the control ON/STOP is in the "ON" mode
when switching on the power.
7.2.3

Checking the last error code

For the buttons and knobs described here, see Figure 7-1,
1. Press Enter. rEF is shown in the display.
2. Turn the knob counter-clockwise, until SUP is shown in the display.
3. Press Enter. FrH is shown in the display.
4. Turn the knob counter-clockwise, until LFt is shown in the display.
5. Press Enter. LIS1 is shown in the display.
6. Turn the knob counter-clockwise, until dP1 is shown in the display.
7. Press Enter. The last error code is shown in the display.
Figure 7-1. Enter button and knob - Schneider
40
HTC 950 RX
page 40
5.0