Changing The Radio Frequency; Interrupted Radio Communication; Making Operation Easier - Husqvarna HTC 950 RX Manuel De L'opérateur

Operation
5. Press in the button "EM-STOP", to switch off the radio control unit.
4.12.5

Changing the radio frequency

If several machines are used in the same workplace, there can be interference with the
radio communication, which means that it is necessary to change the frequency on a
machine. It may also be necessary to change the radio frequency, if there is other
equipment used in the workplace that causes interference with the radio communication.
Change the frequency by doing the following:
1. Stop the machine, for how this is done see under Stop the machine - Radio control,
page 31.
2. Press and hold in the button to start radio communication.
3. Press on the frequency button "FREQ". The machine's radio receiver automatically
searches for the new frequency, the number of the selected frequency channel is
shown briefly on the radio control unit's display. Press on the frequency button
"FREQ" to see the selected frequency channel while operating.
Note!
If the error code "Jt" is shown on the display, immediately contact the HTC
Service Centre for instructions.
4. Release the button to start radio communication.
5. Start the machine, for how this is done see under Start the Machine - Radio Control,
page 31.
4.12.6

Interrupted radio communication

If the distance between the machine and the radio control unit becomes too great, the
radio communication will be broken and the machine stops. In order to restart operation
via the radio control unit, follow the instructions under Start the Machine - Radio
Control, page 31.
4.13

Making operation easier

In order to keep the suction hose for the dust extractor and the power cable out of the
working area and/or path of the machine, the hose and cable can be arranged as shown
in the picture below.
32
HTC 950 RX
5.0