Daily; Every Week; Every Month (Or After 100 Hours) - Husqvarna HTC 950 RX Manuel De L'opérateur

HTC 950 RX
• Recharge/replace the batteries when L" appears in the display and blinks quick,
see Figure 3-4, page 14.
1. Stop the machine, see under Stop the machine - Radio control, page 31.
2. Loosen the battery cover by screwing the screws out on the cover
3. Remove the old/flat batteries.
4. Replace with the new/charged batteries.
5. Close the cover and fasten it in place with the screws.
6. Start the machine, see under Start the Machine - Radio Control, page 31.
5.5

Daily

• Wash the machine if it is used for wet grinding.
• Check for wear to the grinding tools – abnormal or uneven wear may indicate a
damaged grinding holder.
• Check the tool holder and grinding holder to ensure that no damage or cracks
have arisen. Replace the parts if there is any damage.
• Remove any residues of building material from the radio control unit.
5.6

Every week

• Wash the machine, see Cleaning, page 34.
• Check the grinding holders. Remove the tools and run the machine in mid air at
the slowest speed. If the grinding holders oscillate or wobble significantly, they
are damaged.
• Check that the upper belt is whole, by turning the large disc in one direction or
the other. If there is resistance the belt is whole, if the disc rotates freely the belt
is broken.
Tip!
Recondition all the grinding holders at the same time.
5.7

Every month (or after 100 hours)

• Tighten anything that may have vibrated loose.
• Check that the grinding cover is whole and undamaged.
• Check the upper belt and replace if necessary.
5.0
Maintenance and repairs
35