Remote Set Up - Programming The Remote Receiver - Empire Comfort Systems Mantis Manuel D'utilisation

Remote Set Up - Programming the Remote Receiv-
er
1. With the fireplace's main electrical power switch off, set up
remote per instructions on pages 5 and 6. After the remote is
set up, ensure that the remote is turned on and active by hold-
ing the "Power" button on the remote until the remote display
panel illuminates.
MAN
2. Turn on the fireplace's main power switch.
3. If the electrical power is present, the red and green control
board LED's will begin to flash alternately.
29432-1-0512
4. Each light will flash four times then the fireplace will enter
standby mode. While in standby mode, the green LED will
flash slowly and the display panel will show a double dash
" - - ".
MODE
SELECT
REMOTE
MANUAL
OFF
BLOWER
SPEED
DISPLAY
Mantis
BACK LIGHT
Note: The remote control receiver automatically searches for
and locks onto the remote control transmitter's signal when the
main power switch is turned on. The remote control transmitter
must be turned on and active for the receiver to lock onto the
signal.
RED LED
GREEN LED
YELLOW LED
UP
MANUAL
FLAME LEVEL
ADJUSTMENT
FLAME
LEVEL
DOWN
Page 7