Before You Start - Empire Comfort Systems Mantis Manuel D'utilisation

Before You Start

1. Verify there is electrical power to the unit.
Turn on the Main Power Switch.
If electrical power is present, the red and green control board
LED's will begin to flash alternately. Each light will flash four times
then the fireplace will enter standby mode. While in standby mode,
the green LED will flash slowly and the display panel will show a
double dash " - - ".
29432-1-0512
If the control board LED's do not activate, verify the fireplace is
plugged in and the breaker is on.
REMOTE
MANUAL
DISPLAY
BACK LIGHT
2. Verify the main gas supply to the unit is on.
The shutoff valve should be in the "OPEN" position.
Remote and Display Panel Diagrams
TEMPERATURE SENSOR
RED LED
GREEN LED
YELLOW LED
MODE
SELECT
OFF
BLOWER
SPEED
Mantis
BATTERY COMPARTMENT
UP
MANUAL
FLAME LEVEL
ADJUSTMENT
FLAME
LEVEL
DOWN
CLOSED
OPEN
LCD DISPLAY
POWER
MODE
ADJUSTMENT
MENU
Page 5