Kärcher G 2600 PH Manuel D'utilisation page 7

STEP 8:
Attach the high pressure hose to the
trigger gun.
CAUTION
Engine shipped without oil. Before start-
ing engine, fill with oil. Do not over-fill.
Do not run the engine with a high or low
oil level as this can cause engine dam-
age.
If you have further questions regarding
the engine, please refer to the engine
manual included with the unit.
STEP 1:
Check oil level. Oil level should al-
ways be between the "FULL" and
"ADD" marks on the dipstick.
Be sure the machine is level when
checking the oil level. (Refer to the
engine's operating manual for sea-
sonal grades.).
We recommend that the oil be
changed after the first 5 hours of
use, then once every 50 hours.
STEP 2:
Fill gas tank with unleaded gasoline.
Do not use leaded gasoline.
Do not add oil to the gasoline.
STEP 3:
Connect the high pressure hose to
the unit's high pressure outlet.
STEP 4:
Connect garden hose to unit's water
inlet.
OPERATING INSTRUCTIONS
STEP 5:
Connect garden hose to the cold wa-
ter source and turn water on com-
pletely.
Do not use hot water.
STEP 6:
Unlock the trigger gun safety lock.
Trigger the gun to eliminate trapped
air, wait for a steady flow of water to
emerge from the spray nozzle.
STEP 7:
Open fuel valve.
Pull the choke rod to the ON position
(on a warm engine, leave the choke
rod in the OFF position).
STEP 8:
Move the engine stop switch to the
ON position.
For engine details see engine manu-
al.
STEP 9:
Pull the starter handle.
If the engine fails to start after
3 pulls, squeeze the trigger gun to
release pressure, and repeat step.
After the engine warms up enough to
run smoothly, move choke rod to
OFF position.
7
English