Components; Installation Procedure; Attaching The Wall Mount Brackets - Panasonic SC-HTB500 Mode D'emploi

Components

The images shown in this installation instructions are for illustrative purpose only.
Check the supplied components before starting.
∏ 2 Wall mount brackets
(RYQX1034-K)
∏ 2 Lock pins
(RYQX1048)
Commercially available components (not supplied)
≥ Screws for wall mounting
≥ Fall prevention cord
≥ Use commercially available screws with a nominal diameter of 4.0 mm (
frame, concrete etc.) you are attaching the wall mount brackets to.
≥ Product numbers correct as of May 2010. These may be subject to change.

Installation procedure

Never use any other method than specified to install.

Attaching the wall mount brackets

Preparation
≥ To prevent damage or scratches, lay down a soft
cloth and perform the assembly on it.
≥ Do not hold this unit in one hand to avoid injury by dropping this unit when carrying.
1
On the rear of the unit:
Place the wall mount bracket by
aligning the holes in the wall mount
bracket with the projecting parts A.
2
Screw the wall mount bracket firmly
into place.
≥Screw tightening torque: 80 N0cm (17.98 lbf-ft) to
120 N0cm (26.98 lbf-ft).
≥Repeat the steps above when installing the second
wall mount bracket.
26
∏ 2 AC power supply cord
(RFAX1027)
∏ 1 Digital transmitter
(RFAX1032A)
≥ Screws to attach fall prevention cord to wall
≥ Keep the screws out of reach of children to
prevent swallowing.

∏ 2 Screws
(RYQX1042-1)
/ q) that are suited to the wall material (wood, steel
5
32