How To Assemble And Use; Important; Control Panels - Hamilton Beach 95903 Mode D'emploi

840157000 ENv03.qxd

How to Assemble and Use

IMPORTANT: Your blender jar and
cutting blades are subject to wear dur-
ing normal use. Always inspect jar for
nicks, chips, or cracks. Always inspect
cutting blades for broken, cracked, or
loose blades. If jar or cutting blades are
damaged, do not use. Call our toll-free
customer service number to obtain
replacement parts.
1. Make sure blender is unplugged.
Place blender base on clean, dry
surface to keep foreign particles
from being pulled up into motor
during operation.
2. For Models with Sure Rest
or Jar Nut:
Place cutting blades in Sure Rest
base or jar nut. Set jar on top of cut-
ting blades and screw Sure Rest
base or jar nut onto jar.
For Models with Cutting Assembly:
Fit gasket over cutting blades. The
gasket must lie flat. Set jar on top
of gasket and screw on cutting
assembly.
3. Make sure the jar nut, Sure Rest™
base, or cutting assembly is firmly
screwed onto the jar. If not, it may
loosen later when motor is turned on.

Control Panels

Your blender may have 6 to 16 speeds.
They all operate similarly. For blenders
with 10 or more speeds, first select and
push a LO or HI power button then push
desired speed button. When using
PULSE the blender will operate only as
long as button is pushed. The remaining
speed buttons will run the blender until
OFF is pushed.
4
1/3/07 11:48 AM Page 4
™ Base
™
™
4. Set assembled jar into place on
blender base, making sure it is
securely seated. (For some models,
turn to LOCK as indicated.) If not,
gently rock the jar until seated.
5. Plug cord into outlet.
6. Put ingredients in jar; place lid with
filler cap on jar. Place hand on lid
when blending thin liquids.
7. Process food or beverages. See
the "Blending Specific Foods" for
speeds and processing tips.
8. ALWAYS turn blender off and wait
until blades have stopped rotating
before removing jar.
9. To remove jar after blending is
complete, lift the jar straight up.
(For some models, turn to
UNLOCK as indicated.) If it is not
easily removed, rock gently and lift.
Do not twist.
10. NEVER replace jar onto unit while
motor is running.
NOTE: Speed increases as the buttons
are pushed left to right.