How To Assemble And Use; Important - Hamilton Beach 50256WV Mode D'emploi

840133000 ENv02.qxd

How to Assemble and Use

IMPORTANT: Your blender jar and
cutting blades are subject to wear dur-
ing normal use. Always inspect jar for
nicks, chips, or cracks. Always inspect
cutting blades for broken, cracked, or
loose blades. If jar or cutting blades are
damaged, do not use. Call our toll-free
customer service number to obtain
replacement parts.
1. Make sure blender is unplugged.
Place blender base on clean, dry
surface to keep foreign particles
from being pulled up into motor
during operation.
2. For Models with Safety Base:
Place blades in safety base. Fit
gasket over blades. The gasket must
lie flat. Set jar on top of gasket and
screw on safety base.
For Models with Cutting Assembly:
Fit gasket over blades. The gasket
must lie flat. Set jar on top of gasket
and screw on safety base.
3. Make sure the safety base is firmly
screwed onto the jar. If not, it may
loosen later when motor is turned on.
6- and 10-Speed Control Panels*
HI
OFF
LO PULSE STIR
GRATE
HI BEAT
OFF
PULSE
LO PUREE
STIR AERATE
4
2/24/05 10:50 AM Page 4
First select and push a LO or HI power but-
BLEND SMOOTHIE
ton then push desired speed button. When
using PULSE or Ice Breaker
PUREE CHOP
blender will operate only as long as button
is pushed. The remaining speed buttons
will run the blender until OFF is pushed.
BLEND SMOOTHIE
* NOTE: On some models with 6 to 12
speeds the highest speed may be referred
CRUMB CHOP
to as SMOOTHIE or LIQUEFY.
4. Set jar into place on blender base,
making sure it is securely seated.
(For some models, turn to LOCK as
indicated.) If not, gently rock the jar
until seated.
5. Plug cord into outlet.
6. Put ingredients in jar; place lid
on jar. Place hand on lid when
blending thin liquids.
7. Process food or beverages. See
the "Blending Techniques" section
for speeds and processing tips.
8. ALWAYS turn blender off and wait
until blades have stopped rotating
before removing jar.
9. To remove jar after blending is
complete, lift the jar straight up.
(For some models, turn to
UNLOCK as indicated.) If it is not
easily removed, rock gently and lift.
Do not twist.
10. NEVER replace jar onto unit while
motor is running.
™ buttons,