Assembly - Chauvet DJ Motion Orb Mode D'emploi

Assembly

MotionOrb User Manual Rev. 66
Before assembling the MotionOrb, read and follow the safety recommendations in the
Notes.
Assemble the MotionOrb from the top down with the power off.
Rig the top bar where the MotionOrb will hang—for more information see Rigging. Then attach
the standard orb strings to the top bar and the bottom orb strings to the standard orb strings—
for more information see the
The top bar of the MotionOrb has male connectors. The standard orb strings have male
connectors on one end and female on the other end. The bottom orb strings have female
connectors on one end and loops on the other end. The bottom orb strings are always at the
bottom of the MotionOrb.
The orb string connectors are 4-pin connectors with locking collars. There is a threaded collar
on the female connector that slides over, and twists onto, the threaded exterior of the male
connector. There are arrows on each connector so that the connectors can be aligned properly
before being screwed together.
To assemble the MotionOrb, do the following:
1. Rig the top bar. For more information see Rigging.
2. Attach each of the standard orb strings directly to the top bar using the female connector
ends of the orb strings.
3. Attach each of the bottom orb strings to the standard orb strings using the male connector of
the standard orb strings and female connector of the bottom orb strings.
4. Make sure all the connections are finger tight.
5. Turn on the power.
· Make sure the power is off before assembling the MotionOrb.
· Standard orb strings will not work on their own! The bottom orb strings must be
connected in order for the product to function!
· The bottom orb strings—the ones with the loops—are always at the bottom of the
MotionOrb.
· Each strand must be at least 2 meters (at least one standard orb string, ending in a
bottom orb string).
Assembly Diagram.
3. Setup
Safety
Page 13 of 94