Back And Seat Replacement - Steelcase Brody 488 Notice De Montage

®
Back and Seat
Replacement
1.
Using a narrow pry bar or glazing bar,
gently slide the pry bar between the top
cap and the lower wall, being careful not
to damage the upholstery.
DO NOT ATTEMPT TO PRY MORE THAN
1 INCH FROM ANY TOP CAP RETAINER
AS THIS WILL RESULT IN DAMAGE TO
THE TOP CAP.
2.
Search for locations of top cap retainers.
Gently pry the top cap upward at the location
of each retainer.
NOTE: Screen versions only have 5
top cap retainers while non-screened
units have 7 on each top cap.
NOTE: Top cap retainers may be one of two
types shown. Removal of top cap with prybar
applies to both types of retainers.
3.
Work around each top cap until all of
the retainers have been disengaged (3a).
Remove top caps (3b).
PRYBAR
1
NON-SCREEN ONLY
3a
2
TOP CAP
PRYBAR
LOWER WALL
TOP CAP RETAINERS
THREADED STUD
COMPRESSION DOWEL
(PRIOR TO 6-20-2016) (AFTER 6-20-2016)
3b
Page 2 of 87
1025192001 Rev C