Steelcase Brody 488 Notice De Montage page 14

Masquer les pouces Voir aussi pour Brody 488:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

®
Non – Personal
Worksurface Bracket
Replacement
(continued)
4.
Using a 6mm Allen wrench,
remove the two (2) M8 fasteners
holding the side surface to the upper
casting on the personal worksurface.
5.
Using a T40 torx bit, remove the
two (2) M6 bolts (5a) and the one (1)
M8 bolt (5b) holding the personal
workurface to the steel frame.
6.
Carefully slide the personal
workurface out from underneath the
side surface.
NOTE: Do not load the side surface
with the support bracket removed.
7.
Reverse steps 4 thru 6 to install
new non-PSW bracket.
NOTE: Side surface
removed from illustration
for clarity.
M8 BOLT
4
NON-PWS BRACKET
5a
M6 BOLT
NON-PERSONAL
WORKSURFACE
BRACKET
UPPER
CASTING
SIDE SURFACE
5b
M8 BOLT
Page 14 of 87
1025192001 Rev C

Publicité

Table des Matières
loading

Table des Matières