®
Install dash mini Light onto a Brody Chair
1.
Remove all contents from box including the light bracket
with nut and hardwire bag.
2.
Place Brody chair onto a clean, scratch resistant furniture pad,
so you can gain access to the bottom of the worksurface.
3.
Pull round end of power cord through slot in worksurface.
4.
Insert light bracket through hole on worksurface.
5.
Tighten nut from bottom of worksurface with 8mm socket wrench.
6.
Slide the anti-rotation disc onto light bracket post using the
alignment tab to seat fully down on the light bracket.
7.
Install the mini dash light onto the light bracket pin making sure
that screw at the bottom of the light arm is inserted into the pocket
of the anti-rotation disc.
8.
Install round end of power cord into dash mini light.
9.
Use outlet on back of power unit for dash mini light power cord.
1
4
3
Tip: Make sure the set screw
aligns with rotational pocket.
7
6
5
8
1025192001 Rev C
9
Page 7 of 87