Operation - Senix GTSX5-M-0 Manuel D'instructions

Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
Wear protective clothing and observe all safety
instructions to prevent serious personal injury.
1. Check the unit as well as accessories for damage
before each use. Do not use the unit if it is damaged
or shows wear.
3. Always hold the unit on its handle. Keep the handle
dry and free from lubricant to ensure safe holding.
4. Ensure that the air vents are always unobstructed
and clear. Clean them if necessary with a soft brush.
Blocked air vents may lead to overheating and
damage the product.
5. Switch the unit off immediately if you are disturbed
while working by other people entering the working
area. Always let the unit come to complete stop
before putting it down.
6. Do not overwork yourself. Take regular breaks to
ensure you can concentrate on the work and have
full control over the product.
CAUTION:
the day and on what special days products are allowed
to be used and what restrictions apply! Ask your
community for detailed information and observe the
regulations in order to preserve a peaceful
neighborhood and avoid committing administrative
offences.
1. Insert the battery pack into battery holder.
2. Make sure the latch on bottom of battery pack snaps
in place and that battery pack is fully seated.
10
a et itc
Hold the product as in working condition. To start the
switch and then press the On/ Off switch and keep it
pressed.
To switch off the machine, release the On/Off switch.
NOTE: For safety reasons, the On/Off switch cannot
be locked; it must remain pressed during the entire

operation.

FEEDING CUTTING LINE
The cutting line will be fed around 12mm automatically
once the product is switch on. Do not switch on and
off the product frequently and/or unnecessarily when
cutting grass.
1. Inspect the area to be cut and remove all debris that
could become entangled in the nylon cutting head.
Also remove any objects that the product may throw
during cutting.
2. The cutting line should run parallel to the lawn
surface in lawn trimming mode and perpendicular to
the lawn surface in lawn edge trimming mode.
3. Run the machine to top speed before cutting.
4. Keep your body and feet in safety distance to cutting
head.
stones, walls and other objects.
6. Check and feed the line regularly to maintain full
cutting width and performance.
7. Do not grip on the metal stem. Always grip on the
insulated handles.
n itc
WWW.SENIXTOOLS.COM