Senix GTSX5-M-0 Manuel D'instructions page 8

Remove the battery pack before assembly. Wear
protective gloves.
1. Install the cutting head shield on the neck of the
cutting head.
2. Install the three bolts to attach the shield. Tighten
securely.
1. Loosely clamp the lower handle on the upper stem.
2. Attach the upper and lower handles with the bolts.
3. Adjust the front handle to a position along the stem
which is suitable for you to hold and guide the
product.
1. Loosen the shaft coupler bolt as shown.
2. Join the two shafts and install the bolt. Do not
overtighten.
8
WWW.SENIXTOOLS.COM