Safety And General Information; Product Description - SFA OMEGA Lift Equipment 22201 Manuel Des Consignes D'utilisation Et Des Pièces

SAFETY and GENERAL INFORMATION

Save these instructions. For your safety, read, understand, and follow the information provided with and on this jack before
using. The owner and operator of this equipment shall have an understanding of this jack and safe operating procedures
before attempting to use. The owner and operator shall be aware that use and repair of this product may require special
skills and knowledge. Instructions and safety information shall be conveyed in the operator's native language before use
of this jack is authorized. If any doubt exists as to the safe and proper use of this jack, remove from service immediately.
Inspect before each use. Do not use if broken, bent, cracked or damaged parts are noted. Any jack that appears damaged
in any way, or operates abnormally shall be removed from service immediately. If the jack has been or suspected to have
been subjected to a shock load (a load dropped suddenly, unexpectedly upon it), immediately discontinue use until jack
has been checked by a factory authorized service center (contact distributor or manufacturer for list of authorized service
centers). It is recommended that an annual inspection be done by qualified personnel. Labels and Operator's Manuals are
available from manufacturer.

PRODUCT DESCRIPTION

This Omega Hydraulic Air/Lever Actuated Service Jack is designed to lift, but not support, one end of a vehicle. Immediately
after lifting, loads must be supported by a pair of appropriately rated jack stands. Air actuated unit requires at least 7.8 CFM
@ 110 - 175 PSI. A minimum of 150 PSI air pressure is required to raise rated capacity load.
WARNING: NEVER use hydraulic jack as stand-alone device. After lifting, immediately support the lifted vehicle
!
with a pair of appropriately rated jack stands.
SPECIFICATIONS
Model
22201
22203
Lift Control Valve
Handle Position Lock
Capacity Jack Size (L x W x H)
62-1/4" x 20-3/8" x 11-3/4"
20 Ton
74" x 20-3/8" x 14-3/8"
Handle
Oil Filler Screw
(below cover plate,
on Reservoir)
Foot Pedal
Figure 1 - Typical Long Chassis Service Jack w/ Air (22203 shown)
Min. Height
7-1/2"
Release Valve
(Handle Knob)
Caster
Handle Sleeve
2
Max. Height
26"
13" 39-1/2"
Saddle
Front Wheel
Caster only on
22203
Saddle Dia.
6-1/8"