Safety And General Information; Product Description - SFA 41100C Manuel Des Consignes D'utilisation Et Des Pièces

SAFETY and GENERAL INFORMATION

Save these instructions. For your safety, read, understand, and follow the information provided with and on this jack
before using. The owner and operator of this equipment shall have an understanding of this jack and safe operating
procedures before attempting to use. The owner and operator shall be aware that use and repair of this product
may require special skills and knowledge. Instructions and safety information shall be conveyed in the operator's
native language before use of this jack is authorized. If any doubt exists as to the safe and proper use of this jack,
remove from service immediately.
Inspect before each use. Do not use if broken, bent, cracked or damaged parts are noted. Any jack that appears
damaged in any way, or operates abnormally shall be removed from service immediately. If the jack has been or
suspected to have been subjected to a shock load (a load dropped suddenly, unexpectedly upon it), immediately
discontinue use until jack has been checked by a factory authorized service center (contact distributor or manufacturer
for list of authorized service centers). It is recommended that an annual inspection be done by qualified personnel.
Labels and Operator's Manuals are available from manufacturer.

PRODUCT DESCRIPTION

Transmission Jack is designed to be used as an aid in the removal and installation of automotive and light truck
transmissions, transfer cases and transaxles. This jack is for use under portable lift equipment, where vehicle must
be supported by a pair of appropriately rated jack stands.
!
NEVER use for any purpose other than those uses outlined above!
SPECIFICATIONS
Model Capacity
41100C 1/2 Ton
42000C 1 Ton
Tilt Adjustment Knob
*Oil Filler Plug (not shown)
(*) refer to replacement parts
illustration for location
Handle
Min. Height Max. Height
9" 24-3/4"
7-7/8" 33-1/2"
Lift Arm
Handle Sleeve
Release Valve Knob
Figure 1- Typical Transmission Jack Components (42000C shown)
Jack Size
28-3/4" x 15"
39-3/8" x 19-1/8"
Saddle Plate
2
Chain
Caster