PREPARATION
Assembly (refer to Figures 1, 2)
Always secure the handle into the handle sleeve by means of the bolt, lock washer and nut provided. Tighten securely to
prevent accidental removal of handle while in use.
Before Use
1. Verify that the product and application are compatible, if in doubt call Omega Technical Service (888) 332-6419.
2. Before using this product, read the operator's manual completely and familiarize yourself thoroughly with the product, its
components and recognize the hazards associated with its use.
3. To familiarize yourself with basic operation, turn the release valve (handle knob):
a. Clockwise until firm resistance is felt to further turning. This is the 'CLOSED' release valve position used to raise the
saddle.
b. Counter-clockwise, but no more than 1 full turn from the closed position. This is the 'OPEN' release valve position used
to lower the saddle.
4. With saddle fully lowered, and release valve closed, pump the handle. If lift arm responds immediately, jack is ready for
use. If jack does not respond, follow Bleading/ Venting Trapped Air instructions below.
5. Pour a teaspoon of good quality air tool lubricant into the air supply inlet of the lift control valve. Connect to air supply,
then squeeze the lift control valve for 3 seconds to evenly distribute lubricant.
Note: These models are equipped with a popular 1/4" NPT air coupler. When installing a different air coupler of your
choice, ensure that thread tape or compound is used when servicing connections. To ensure dependable, trouble free
operation an inline air dryer and oiler is recommended.
6. Ensure that jack rolls freely. Raise and lower the unloaded saddle throughout the lifting range before putting into service
to ensure the pump operates smoothly. Replace worn or damaged parts and assemblies with authorized replacement
parts only.
Bleeding / Venting Trapped Air
With the release valve in the OPEN position (3b.) and with saddle fully lowered, locate and remove the oil filler plug/screw.
Pump 6 to 8 full strokes. This will help release any pressurized air which may be trapped within the reservoir. Reinstall the
oil filler plug/screw.
WARNING
!
• Study, understand, and follow all printed
materials provided with/on this product before use.
• Do not exceed rated capacity.
• Use only on hard, level surface.
• This is a lifting device only! Immediately
after lifting, support the load with a pair of
appropriately rated jack stands.
• Only attachments and/ or adapteres supplied by
the manufacturer shall be used.
• Lift only on areas of the vehicle as specified by
the vehicle manufacturer.
• Never wire, clamp or otherwise disable the lift
control valve to function by other than operator's
hand.
• Do not move or dolly the vehicle while on the jack.
• No alterations shall be made to this product.
• Failure to heed these markings may result in
personal injury and/or property damage.
!
To avoid crushing and related injuries:
• Never work on, under or around a load supported
only by hydraulic jack.
• Always use adequately rated jack stands.
• Chock each unlifted tire in both directions.
• Do not use this device to lift, level, lower, support nor
move a house, mobile home, travel trailer, camper or
any building structure.
• Be alert and sober when using this product. Do not
operate under the influence of drugs or alcohol.
3
WARNING