Gigaset 5040 Mode D'emploi page 15

Notice:
The installation of the base unit should allow at least 8 inches
between the base and persons to be in compliance with FCC RF
exposure guidelines.
For body worn operation, the portable part (handset) has been
tested and meets FCC RF exposure guidelines. Use with an
accessory that contains metal parts may not ensure compli-
ance with FCC RF exposure guidelines.
Notice to telephone company service:
If you need service from your telephone company, please pro-
vide them with the information
– Facility interface Code (FIC)
– Service Order Code (SOC)
– Universal Service Order Code (USOC)
as indicated on the label on the bottom side of the base station.
Safety precautions
Before using your telephone equipment, basic safety instruc-
tions should always be followed to reduce the risk of fire, elec-
tric shock and injury to persons.
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Unplug this product from the wall telephone jack and power
outlet before cleaning. Do not use liquid cleaners or aerosol
cleaners. Use damp cloth for cleaning.
4. Do not use this product near water, for example, near a bath-
tub, wash bowl, kitchen sink, or laundry tub, in a wet basement
or near a swimming pool.
5. Place this product securely on a stable surface. Serious dam-
age and/or injury may result if the unit falls.
6. Slots or openings in the cabinet and the back and bottom are
provided for ventilation, to protect it from overheating. These
openings must not be blocked or covered. This product should
never be placed near or over a radiator or heat register, or in a
place where proper ventilation is not provided.
7. This product should be operated only from the type of power
source indicated on the marking label. If you are not sure of the
type of AC line power to your home, consult your dealer or local
power company.
8. Do not place objects on the power cord. Install the unit
where no one can step or trip on the cord.
9. Do not overload wall outlets and extension cords as this can
result in the risk of fire or electric shock.
10. Never push objects of any kind into this product through
cabinet slots as they may touch dangerous voltage points or
15
en
short out parts that could result in the risk of fire or electric
shock. Never spill liquid of any kind on this product.
11. To reduce the risk of electric shock or burns, do not disas-
semble this product. Take it to a qualified service center when
service is required. Opening or removing covers may expose
you to dangerous voltages, dangerous electrical current or
other risks. Incorrect reassembly can cause electric shock when
the appliance is subsequently used.
12. Unplug the product from the wall outlet and refer servicing
to qualified service personnel under the following conditions:
a.) When the power cord is damaged or frayed.
b.) If liquid has been spilled into the product.
c.) If the product has been exposed to rain or water.
d.) If the product does not operate normally by following the
operating instructions. Adjust only those controls that are cov-
ered by the operating instructions because improper adjust-
ment of other controls may result in damage and may require
extensive work by a qualified technician to restore the product
to normal operation.
e.) If the product has been dropped or physically has been
damaged.
f.) If the product exhibits a distinct change in performance.
13. Avoid using a telephone (other than a cordless type) during
a thunderstorm. There may be a remote risk of electrical shock
from lightning. Therefore we suggest a surge arrestor.
14. Do not use the telephone to report a gas leak in the vicinity
of the leak.
15. Emergency/911 numbers may not be dialed if the keypad is
locked.
16. Minimum No. 26 AWG telecommunication line cord must
be used with this phone.
CAN/CSA C22.2 No.60950-1
3161506
ETL LISTED
CONFORMS TO
ANSI/UL STD 60950-1
CERTIFIED TO