Care And Maintenance - Kobalt KMP 2080A-06 Mode D'emploi

CARE AND MAINTENANCE

Replacing the cutting blade
WARNING
Always protect your hands by wearing heavy gloves and/or wrapping the cutting edges with rags or
other materials when performing any maintenance on the blades. Always remove the battery when
servicing or transporting the mower.
Use only a Kobalt replacement blade (Item #0648547, sold separately).
• Remove battery.
• While wearing leather padded gloves, wedge a block of
wood between the blade and the mower deck in order
to prevent the blade from turning when the nut is being
removed.
• Using an adjustable wrench or 27mm socket (not
included), loosen the blade bolt (U) and remove the
blade (T). Turn the bolt counterclockwise to loosen it
and clockwise to tighten it.
• Remove the bolt and the blade.
• To re-install the blade, position the blade with the
cutting edges toward the ground. Assemble the bolt as
shown. Using a socket or wrench, turn the blade bolt
"CLOCKWISE" in order to secure the blade.
Cleaning the mower
WARNING
• In order to reduce the risk of electric shock, do not expose the mower to water. The underside of
the mower deck should be cleaned after each use, because grass clippings, leaves, dirt, and other
debris will accumulate, which will cause rust and corrosion.
• Remove any build-up of grass and leaves on or around the motor cover (do not use water). Occa-
sionally wipe the mower clean with a dry cloth. If debris builds up on the underside of the mower
during use, stop the motor, remove the battery, and then tilt the mower on its side, and scrape it
clean using an appropriate tool.
1
21
Block of wood
T
U