Battery Charger - Kobalt KMP 2080A-06 Mode D'emploi

SAFETY INFORMATION
BATTERY & CHARGER
CAUTION
Use only Kobalt approved replacement batteries. Other batteries may cause injury or damage to the
mower. For use only with Kobalt KB 280-06 battery and KRC 30-06 charger.
BATTERY SAFETY RULES
• Battery tools do not have to be plugged into an electrical outlet; therefore, they are always in op-
erating condition. Be aware of possible hazards when not using your battery tool or when chang-
ing accessories. Following this rule will reduce the risk of electric shock, fire, or serious personal
injury.
Do not place battery tools or their batteries near fire or heat. This will reduce the risk of explosion
•
and possibly injury.
• Do not crush, drop or damage battery pack. Do not use a battery pack or charger that has been
dropped or received a sharp blow. A damaged battery is subject to explosion. Properly dispose of
a dropped or damaged battery immediately.
• Batteries can explode in the presence of a source of ignition, such as a pilot light. To reduce the
risk of serious personal injury, never use any cordless product in the presence of open flame. An
exploded battery can propel debris and chemicals. If exposed, flush with water immediately. Do
not charge battery tool in a damp or wet location. Following this rule will reduce the risk of electric
shock.
• For best results, your battery tool should be charged in a location where the temperature is more
than 42.8°F (6ºC) but less than 104°F (40ºC). To reduce the risk of serious personal injury, do not
store outside or in vehicles.
• Under extreme usage or temperature conditions, battery leakage may occur. If liquid comes in
contact with your skin, wash immediately with soap and water. If liquid gets into your eyes, flush
them with clean water for at least 10 minutes, then seek immediate medical attention. Following
this rule will reduce the risk of serious personal injury.
• When battery pack is not in use, keep it away from other metal objects like: paper clips, coins,
keys, nails, screws, or other small metal objects that can make a connection from one terminal to
another. Shorting the battery terminals together may cause sparks, burns, or a fire.
• Always remove battery pack from your tool when you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery pack will prevent accidental starting that could
cause serious personal injury.
• Always remove battery pack before storing the device. When battery becomes fully charged, un-
plug the charger from the power supply and remove the battery pack from the charger.
• Always wear eye protection with side shields marked to comply with ANSI Z87.1, along with hear-
ing protection. Failure to do so could result in objects being thrown into your eyes and other possi-
ble serious injuries.
• Keep battery pack dry, clean, and free from oil and grease. Always use a clean cloth when clean-
ing. Never use brake fluids, gasoline, petroleum-based products, or any solvents to clean battery
pack.
10