Installing Throttle Cable - Marshalltown Shockwave Power Screed SW100H Mode D'emploi

ASSEMBLY INSTRUCTIONS

INSTALLING THROTTLE CABLE:

Step 1 – Remove carburetor cover by pressing clips.
Step 3 – Fasten the throttle cable as shown. Make sure
there is a nut on each side of plastic fitting. Made sure the
cable does not work itself out of the plastic fitting
while tightening.
WS570
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
04-2018/Rev.B
B
Step 2 – The throttle has a rotating silver peg (A) with a slot
on one side of it. One end of the throttle cable has a metal
barrel (B) that fits into this slot. Insert barrel into the slot so
when the throttle cable is pulled, it will pull the throttle open
(toward the base plate of the screed).
Step 4 – Attach the throttle lever to the "T" grip handle,
as shown above.
A
5 of 48