Attaching Blade - Marshalltown Shockwave Power Screed SW100H Mode D'emploi

Step 5 – Thread the exposed metal end of the throttle cable
into the throttle lever. The lever will need to be "opened" to
expose the hole it fits into. Back out the set screw to allow
the cable to pass through.
Step 7 – Secure throttle cable using clips,
as shown above.
6 of 48
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
ASSEMBLY INSTRUCTIONS
Step 6 - Once cable is through throttle lever, return the
lever to the "idle" position shown above. Using pliers, pull
all extra slack out of the cable, making sure you are not
actually opening the throttle at the carburetor. Once all
slack is removed, tighten locking screw.
Note – the plastic housing of the throttle cable will fit up into
the throttle cable housing.

ATTACHING BLADE

Attach blade as shown,
making sure that blade
is positioned on the
"front side" of the base
extrusion.
Make sure bolts
!
are tight before
each use.
WS570
04-2018/Rev.B