Installing Throttle Cable - Marshalltown SW100H Mode D'emploi

Step 1 – Remove carburetor cover by pressing clips.
Step 3 – Fasten the throttle cable as shown. Make sure
there is a nut on each side of plastic fitting. Make sure
the cable does not work itself out of the plastic fitting
while tightening.
6 of 16
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com

INSTALLING THROTTLE CABLE

B
Step 2 – The throttle has a rotating silver peg (A) with a
slot on one side of it. One end of the throttle cable has a
metal barrel (B) that fits into this slot. Insert barrel into
the slot so when the throttle cable is pulled, it will pull the
throttle open (toward the base plate of the screed).
Step 4 – Attach the throttle lever to the "T" grip handle,
as shown above.
A
WS#570