Fuel And Oil; How To Operate - Marshalltown Shockwave Power Screed SW100H Mode D'emploi

Règle vibrante
Masquer les pouces Voir aussi pour Shockwave Power Screed SW100H:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

FUEL AND OIL

Make sure gas tank has plenty of 86 octane or
higher gasoline. Your 4 stroke Honda engine uses
straight gasoline, NEVER USE A GAS/OIL MIX.
Empty entire bottle of provided Honda engine oil
into crank case. 3.5 oz. is the maximum oil
capacity. Always lay screed down on roll cage as
shown when filling gas and oil or checking oil.
NEVER OVERFILL.
STARTING
1. On a cold engine, move choke lever to CLOSED
position. To restart a warm engine leave choke in
OPEN position
2. Press priming bulb repeatedly until fuel can be
seen in the clear-plastic fuel-return tube
3. Press On/Off Switch to the On Position.
4. Pull the starter grip lightly until you feel resistance,
then pull briskly. Repeat until engine starts.
5. If the choke lever was moved to the CLOSED
position to start the engine, gradually move it to
the OPEN position as the engine warms up.
RESTARTING A WARM ENGINE
1. Leave the choke lever in the OPEN position.
2. If there is no fuel in the clear-plastic fuel-return
tube, press priming bulb repeatedly
until fuel can be seen in the tube.
3. Press On/Off Switch to the On Position
4. Pull the starter grip lightly until you feel resistance,
then pull briskly. Repeat until engine starts.
WS570
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
04-2018/Rev.B

HOW TO OPERATE

1
2
3
4
CLOSED
OPEN
13 of 48

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

13261ShockwaveSw100h

Table des Matières