Assembly Instructions - Marshalltown Shockwave Power Screed SW100H Mode D'emploi

ASSEMBLY INSTRUCTIONS

Your Shockwave™ Screed power unit ships in two boxes, one containing the
handle bars and the other containing the power unit. Assembly is easy,
following these steps:
INSTALLING HANDLE BARS AND KICKSTAND:
Step 1 –
Remove the 4 hex screws (A) that hold down the two
.
handle mounting blocks
A
Step 2 – Slide kickstand arm onto kickstand end and fasten
with nut & bolt (B) as shown
B
Step 3 – Place handle bars into mounting blocks, making sure
handle bars are centered evenly across the mounting blocks.
Step 4 – Making sure all mounting block and frame holes are
aligned, insert hex screws and tighten with 7/16" wrench or
socket.
WS570
4 of 48
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
04-2018/Rev.B