Tadano GR-1000EX-4 Mode D'emploi page 8

General · Allgemein · Généralités
Generalidades · Generalità
Carrier specifications
TYPE
Rear engine, left-hand drive, driving axle 2-way selected type
by manual switch, 4x2 front drive, 4x4 front and rear drive.
FRAME
High tensile steel, all welded mono-box construction.
ENGINE
Model Cummins B6.7
[EU Stage V]
Type Direct injection diesel
No. of cylinders 6
Combustion 4 cycle, turbo charged and after cooled
Bore x Stroke, mm 107 x 124
Displacement, liters 6.7
Air inlet heater 24 volt preheat
Air cleaner Dry type, replaceable element
Oil filter Full flow with replaceable element
Fuel filter Full flow with replaceable element
Fuel tank, liters 300, right side of carrier
Cooling Liquid pressurized, recirculating by-pass
Radiator Fin and tube core, thermostat controlled
Fan, mm Suction type, 9-blade, 711 dia.
Starting 24 volt
Charging 24 volt system, negative ground
Battery 2x120 Ah
Compressor, air, l /min 481 at 2,400 min
Output, Max. kW (HP) Gross 209 (280) at 2,200 min
Torque, Max. Nm 1,152 at 1,500 min
Capacity, liters
Coolant water 10
Lubrication 15
Fuel 300
AdBlue 57
TRANSMISSION
Electronically controlled fully automatic transmission.
Torque converter driving full powershift with driving axle selector.
6 forward and 2 reverse speeds, constant mesh.
3 speeds - high range - 2-wheel drive; 4-wheel drive
3 speeds - low range - 4-wheel drive
TRAVEL SPEED - 18 km/h
8 | GR-1000EX-4
-1
-1
-1
GRADEABILITY - 84% (at stall), 57%*
* Machine should be operated within the limit of engine crankcase
design (30˚: Cummins B6.7)
AXLE
Front: full floating type, steering and driving axle with planetary
reduction.
Rear: full floating type, steering and driving axle with planetary
reduction and non-spin rear differential.
STEERING
Hydraulic power steering controlled by steering wheel.
4 steering modes available: 2 wheel front, 2 wheel rear, 4 wheel
coordinated and 4 wheel crab.
SUSPENSION
Front: rigid-mounted to the frame.
Rear: pivot-mounted with hydraulic lockout device
BRAKE SYSTEMS
Service: air over hydraulic disc brakes on all 4 wheels.
Parking/Emergency: spring-applied, air-released brake acting
on input shaft of front axle.
Auxiliary: electro-pneumatically operated exhaust brake.
TIRES - 29.5-25 36PR (OR) Air pressure: 470 kPa
29.5-25 40PR (OR) Air pressure: 465 kPa
OUTRIGGERS
4 hydraulic, beam and jack outriggers.
Vertical jack cylinders equipped with integral holding valve.
Each outrigger beam and jack is controlled independently from cab.
Beams extend to 7.3 m center-line and retract to within 3.315 m
overall width with pads. Outrigger pads are attached thus eliminating
the need of manually attaching and detaching them. Controls and sight
bubble located in superstructure cab. 4 outrigger extension lengths are
provided with corresponding „RATED LIFTING CAPACITIES" for crane
duty in confined areas.
Min. extension 2.7 m center to center
Mid. extension 5.5 m center to center
Mid. extension 6.7 m center to center
Max. extension 7.3 m center to center
Pad size (Diameter) 0.6 m