Set Up; Important Parts Of Your Smartlink Module; Connection To The Cpap - DeVilbiss Healthcare SmartLink DV5M Manuel D'utilisation

seT up

source when performing cleaning.
• Do not insert any foreign objects into any openings.
CAUTION– The circular data port and oximeter connectors located on the side
of the SmartLink Module are used to attach accessories to the
device. The connectors must only be used with accessories
approved for use by DeVilbiss. Do not attempt to attach any other
device to these connectors as it may damage the CPAP, SmartLink
Module, and/or the device you are attempting to attach.
Be sure that you read and understand the information in this instruction guide. The
information in this guide will help you understand the operation of the Smartlink Module and
how to properly maintain it. By following these instructions and the advice of your physician,
your SmartLink Module will become an effective addition to your CPAP therapy.
SAVE THESE INSTRUCTIONS
SET UP

Important Parts Of Your SmartLink Module

1. Data card slot
2. Release button
3. Secondary accessory data connection port
4. Oximeter connection port
5. Primary data connector
6. Locking tabs (3 tabs)
7. Instruction Guide (not shown)

Connection To The CPAP

NOTE
– Your CPAP may already have been provided to you
with the SmartLink attached. If you have received
your module separately from the CPAP, follow the
steps below to properly attach the module to the
CPAP.
EN
A
1
3 4
2
3
4
2
B
6
6
5 6
A-DV5M-1
5